The tilting crane is an important piece of equipment in the AAC block manufacturing plant. It is used after the pre-curing process to de-mold the “green cake” in the mold. The main component of the AAC tilting machine is the lifting hook, the swinging ring, twist locks, ear plates, rigging shackles, etc. It uses a hydraulic propeller to automatically control the opening and closing of hooks.
The tilting crane from CNBM can run at a certain speed. It can reduce the damage to the “green cake” and improve the rate of the finished product. Other AAC block making machines are supplied as well.
Highlights of cNBM tilting crane
The tilting crane from CNBM can run at a certain speed. It can reduce the damage to the “green cake” and improve the rate of the finished product.
The connection between the load beam and the lifting point of the crane can not only make the crane turn horizontally but also make the lifting accessories turn vertically. The crane always takes this point as the rotating shaft point in the operation process and can run horizontally by adjusting the height position of the two lifting points behind.
The lifting cylinder is used to lift the crane. Through the meshing of the synchronously moving gear and the rack, and with the function of the guide wheel, the simultaneous lifting of the lifting points at the four corners of the crane is realized with rigid guidance. The propulsion cylinder drives the connecting rod mechanism to realize the grabbing hook, safe and reliable.
It has advantages over driving cranes in many aspects such as the installation height, span, power consumption, and material costs. Thus, the cost is greatly reduced and saved.
Get An Immediate Quote!The working principle of the tilting crane
The tilting crane lifts the pre-cured “green cake” with the mold up in the air and flips it 90 degrees. The side plate of the mold is released and the “cake” is removed from the mold with the side plate. Then the “green cake” is transferred to the cutting machine. In addition, the tilting crane lifts the empty mold to combine with the sent back side plate and transfer it to the pouring area for the next shift.
